What are some of the general safety tips for working with or near electrical components?
Inspect portable cord-and-plug connected equipment, extension cords, power bars, and electrical fittings for damage or wear before each use. Repair or replace damaged equipment immediately.
Always tape extension cords to walls or floors when necessary. Nails and staples can damage extension cords causing fire and shock hazards
Use extension cords or equipment that is rated for the level of amperage or wattage that you are using.
Always use the correct size fuse. Replacing a fuse with one of a larger size can cause excessive currents in the wiring and possibly start a fire.
Be aware that unusually warm or hot outlets may be a sign that unsafe wiring conditions exists. Unplug any cords or extension cords to these outlets and do not use until a qualified electrician has checked the wiring.
Always use ladders made with non-conductive side rails (e.g., fibreglass) when working with or near electricity or power lines.
Place halogen lights away from combustible materials such as cloths or curtains. Halogen lamps can become very hot and may be a fire hazard.
Risk of electric shock is greater in areas that are wet or damp. Install Ground Fault Circuit Interrupters (GFCIs) as they will interrupt the electrical circuit before a current sufficient to cause death or serious injury occurs.
Use a portable in-line Ground Fault Circuit Interrupter (GFCI) if you are not certain that the receptacle you are plugging your extension cord into is GFCI protected.
Make sure that exposed receptacle boxes are made of non-conductive materials.
Know where the panel and circuit breakers are located in case of an emergency.
Label all circuit breakers and fuse boxes clearly. Each switch should be positively identified as to which outlet or appliance it is for.
Do not use outlets or cords that have exposed wiring.
Do not use portable cord-and-plug connected power tools with the guards removed.
Do not block access to panels and circuit breakers or fuse boxes.
Do not touch a person or electrical apparatus in the event of an electrical accident. Always disconnect the power source first.
What are some of the general safety tips for working with or near electrical components?Inspect portable cord-and-plug connected equipment, extension cords, power bars, and electrical fitt …
What are some tips for working with power tools ?Switch all tools OFF before connecting them to a power supply.Disconnect and lockout the power suppl …
What are some tips for working with power cords ?Keep power cords clear of tools during use.Suspend extension cords temporarily during use over aisle …