Blog

Switch all tools OFF before connecting them to a power supply.Disconnect and lockout the power supply before completing any maintenance work tasks or making adjustments.Ensure tools are properly grounded or double-insulated. The grounded equipment must have an approved 3-wire cord with a 3-prong plug. This plug should be plugged in a properly grounded 3-pole outlet.Test all tools for effective grounding with a continuity tester or a Ground Fault Circuit Interrupter (GFCI) before useDo not bypass …

Keep power cords clear of tools during use.Suspend extension cords temporarily during use over aisles or work areas to eliminate stumbling or tripping hazards.Replace open front plugs with dead front plugs. Dead front plugs are sealed and present less danger of shock or short circuit.Do not use light duty extension cords in a non-residential situation.Do not carry or lift up electrical equipment by the power cord.Do not tie cords in tight knots. Knots can cause short circuits and shocks. Loop th …

A Class A Ground Fault Circuit Interrupter (GFCI) works by detecting any loss of electrical current in a circuit (e.g., it will trip at a maximum of 6mA). When a loss is detected, the GFCI turns the electricity off before severe injuries or electrocution can occur. A painful non-fatal shock may occur during the time that it takes for the GFCI to cut off the electricity so it is important to use the GFCI as an extra protective measure rather than a replacement for safe work practices.GFCI wall ou …

Inspect Cords and PlugsCheck extension cords and plugs daily. Do not use, and discard if worn or damaged. Have any extension cord that feels more than comfortably warm checked by an electrician.Eliminate Octopus ConnectionsDo not plug several items into one outlet.Pull the plug, not the cord.Do not disconnect power supply by pulling or jerking the cord from the outlet. Pulling the cord causes wear and may cause a shock.Never Break OFF the Third Prong on a PlugReplace broken 3-prong plugs and mak …